Seminar | Shot Peening Full report and PPT Download
to Shot Peening
Shot peening is a cold working process in
which the surface of a part is bombarded with small spherical media called
shot. Each piece of shot striking the metal acts as a tiny peening hammer,
imparting a small indentation or dimple on the surface. In order for the dimple
to be created, the surface layer of the metal must yield in tension. Below the surface, the compressed grains
try to restore the surface to its original shape, producing a hemisphere of
cold-worked metal highly stressed in compression . Overlapping
Dimples develop a uniform layer of residual compressive stress.
|Fig1. Principle Of Shot Peening Process|
Equipment Used for Shot Peening
classification arrangements, and a work handling conveyor.
|Fig. Shot Peening Machine|
Methods Used For Shot Peening
Conventional (Mechanical) Shot Peening –
Conventional shot peening is done by two methods. Method one involves accelerating shot material with compressed air. Shot is introduced into a high velocity air stream that accelerates the shot to speeds of up to 250 ft/s. The second method involves accelerating the shot with a wheel.
Laser-shot Peening –
Laser-shot peening utilizes shock waves to induce residual compressive stress. The primary benefit of the process is a very deep compressive layer with minimal cold working. Layer depths up to 0.40” on carburized steel and 0.100” on aluminum alloys have been achieved. Mechanical peening methods can only produce 35% of these depths.
Dual peening further enhances the fatigue performance from a single shot peen operation by re-peening the same surface a second time with smaller shot and lower intensity. Peening the surface a second time drives the peaks into the valleys, further increasing the compressive stress at the surface.
Where dual peening increases the compressive stress on the outer surface of the compressive layer, strain peening develops a greater amount of compressive stress throughout the entire compressive layer. This additional stress is generated by preloading the part within its elastic limit prior to shot peening. When the peening media impacts the surface, the surface layer is yielded further in tension because of the preloading. The additional yielding results in additional compressive stress when the metal’s surface attempts to restore itself.
The choice of shot peening parameters is dependent on a variety of conditions:
- Knowledge of the application of the component
- Component geometry
- Manufacturing method
- Mechanical properties of the base material
- Strain sensitivity of the base material
- Service conditions, loads and cycles
- Cost sensitivity
Application of Shot Peening
After Some Manufacturing Processes
Processes like Grinding , Electro Discharge machining (EDM), Plating , Electro-Chemical Machining (ECM), Anodizing, Plasma, Decarburization
- Jet Engine Blades
- Connecting Rods
- Shafts and Axles
- Torsion Bars
|Fig. Shot Peening Of the Gear|
- Enhances fatigue strength.
- Improves ultimate strength.
- Prevents cracking due to wear.
- Prevents corrosion.
- Prevents fretting.
- Possible to increase the fatigue strength of damaged parts extending the wear.
- Increases lubricity by creating small pores in which lubricants can accumulate.
- Leaves a uniformly textured, finished surface ready for immediate use or paint and coatings.
- Can be used to curve metal or straighten shafts without creating tensile stress in a Peen forming process.
|Fig. Shot Lining|
- Introduction to shot peening
- Difference between shot peening and shot blasting ??
- Equipment used for shot peening
Process control parameters
Application of shot peening in for various purposes
Benefits and limitations of shot peening