Flywheel Based Battery Charger Mechanical Project 

Setup of Flywheel Based battery Charger
Setup of Flywheel Based battery Charger 
  • This project, as name suggest is about fabrication of a battery charger that uses flywheel
    for the purpose.
  • In its simple construction the project model uses a flywheel made up of steel, MDF, iron
    etc. basically the flywheel is made using two and more component for durability and cost
    saving. This flywheel is made to run by human power, which is transmitted to the same
    using paddle, sprocket, chain and free wheel mechanism. 
  • The mechanical power from
    this flywheel is then transmitted to the electricity generator using transmission that
    multiplicities the speed of flywheel and then transmit it to the generator unit. 
  • The
    mechanical power from the flywheel thus gets converted into electric power that is there
    after stored in a secondary battery using a charging circuit that has various functionalities
    associated with it like wise overcharging protection, low discharge cut off, high voltage
    cut off, current back flow proofing etc. 
  • The whole assembly is put together in a space
    frame made up of iron. As far as
    possible the frame is made portable
    and easy to carry.
    The capacity of the project can be
    varied from 1.5 volt battery charging
    to 12 volt battery charging. The size
    of the project work varies as that of
    capacity.
  • This project has very potential to
    considering commercial point of
    view. As load shedding is major on going issue in remote, rural as well as urban area.
    This device can perform well for agricultural as home use. In urban area this device can
    also perform the work of exercising machine as well as can also be used for back to
    electricity. 
  • Thus the device can play multiple roles in everyday life.
    The project work can be made on full scale as well as scale down version, but in both
    cases the project is fully functional or working in nature.